17. November 2026
Tracing a photo into a stencil: by hand, or with a tool.
You can trace a stencil by hand, with a light box, or let software trace the photo. Each has a real cost in time and control. Here is how to pick.
Tracing by hand
By hand, you place the reference under tracing paper or a light box and draw the lines yourself. You keep full control of which edges survive and how thick each line is.
The cost is time and consistency. A detailed photo can take an hour or more, and the line weight drifts across the sheet because your hand is not a constant.
Letting software trace it
A trace tool reads the photo and decides the edges for you: contrast, smoothing, threshold, then a line weight you set once. The result is consistent across the whole sheet, because one rule drew every line.
The cost is control. You steer the result with a few sliders (pass, detail, thickness) rather than a pencil. For most photos that is enough. For a piece where one specific edge matters, you may still touch it up by hand.
Where a tool wins
Any photo with lots of edges and texture: fur, hair, foliage, a busy portrait. Software holds the line weight steady where a hand drifts. It is also repeatable. Export the same photo twice and you get the same sheet, which matters when you print at two sizes.
It also prints at a true size. Set the width in centimetres and the sheet comes out at that width, which is fiddly to do by hand.
Where a hand wins
A design that is mostly the artist's own linework, or one where you want to drop a specific shadow and keep a specific edge. A tool traces what is in the photo. It will not make an editorial decision about what matters.
The honest split: software for the first pass and the base sheet, your hand for the parts a rule cannot judge.
The practical answer
Trace with the tool first, then fix by hand if you need to. You start from a clean, consistent, true-size sheet instead of a blank page, and you spend your hand-work only where it changes the result.
Three sheets are free, so the test is cheap: run your own photo through, print it at size, and see whether the lines are good enough to ink from.